The short version of Epithalamin fits in a sentence. The long version — which is the one that helps — is below.
Reviewed 2025-11-07. Anything still debated is marked as such rather than presented as settled.
Identity and purity of epitalon samples are normally established by reversed-phase high-performance liquid chromatography with ultraviolet detection near 214 nanometres, combined with mass spectrometry. The mass spectrum confirms the expected molecular ion and can reveal truncated or oxidised by-products. Amino acid analysis after acid hydrolysis verifies that the four residues are present in the expected ratio. Certificates typically report a purity figure taken from chromatographic peak area, expressed as a percentage of total integrated signal.
Lyophilised epitalon is generally held at minus twenty degrees Celsius in a sealed container kept dry and dark. Cooler conditions are sometimes recommended for long-term archives. The solid takes up moisture readily enough that repeated opening of a vial introduces water, so dividing a batch into smaller portions before storage lowers degradation risk. Aqueous solutions are less durable than the dry powder and are usually prepared shortly before use, then kept cold and shielded from light to slow hydrolysis and oxidation.
Verification of research-grade material involves comparing a supplier chromatogram against an in-house reference, checking the observed mass against the calculated value, and where possible confirming residue order by tandem mass spectrometry or enzymatic peptide mapping. Purity claims should be read alongside the method used to obtain them, because detection wavelength and integration settings alter the result. Batch-specific data, rather than a generic grade statement, is the informative part of a certificate.
The compound is described in the literature as a derivative of epithalamin, a preparation obtained from bovine pineal tissue. Work on this peptide family was carried out mainly by a research group in Saint Petersburg beginning in the 1980s, and the substance was later registered for clinical use in Russia under the name Epitalon. Outside that region it is generally treated as a research chemical rather than an approved medicine. Statements about its biological activity rest on a relatively small number of studies, and independent replication remains limited.
In its supplied form epitalon is a white to off-white powder, usually lyophilized and often hygroscopic. It dissolves readily in water and in aqueous buffers, and it is commonly handled as the acetate or trifluoroacetate salt to improve stability during purification and drying. The amide backbone is labile in aqueous media, so solutions are less durable than the dry solid. Handling notes in the chemical literature therefore emphasize keeping the powder dry, cool and shielded from light until it is dissolved.
| Property | Value | Notes |
|---|---|---|
| Typical purity specification | 95 percent or higher by HPLC area | Higher grades are also offered |
| Primary analytical method | Reversed-phase HPLC, UV detection | Frequently paired with mass spectrometry |
| Confirmatory technique | Electrospray mass spectrometry | Observed mass compared with theory |
| Storage temperature | Minus 20 degrees Celsius, dry powder | Sealed, desiccated, protected from light |
| Solution handling | Prepare fresh before use | Hydrolysis proceeds in aqueous media |
Laboratory handling begins with dissolution of the lyophilized powder in water or a suitable aqueous buffer. The dry solid is the more stable form, so stock solutions are generally prepared only when required and kept cold afterwards. Repeated freezing and thawing of a solution is avoided because it encourages aggregation and gradual loss of the intact chain. Diluents and containers are selected to limit adsorption of a short peptide onto plastic surfaces and to reduce microbial growth in aqueous preparations.
Stability depends strongly on pH, temperature and the presence of oxygen and trace metals. Cleavage of the backbone proceeds faster under neutral to alkaline conditions, whereas acidic solutions tend to slow that reaction. The aspartate and glutamate side chains can undergo deamidation or imide formation over time, generating closely related impurities. Published stability data specific to epitalon are sparse, so the usable life of a given solution is best regarded as an open question that depends on buffer composition, concentration and storage temperature.
Identity and purity are usually assessed by reversed-phase high-performance liquid chromatography with ultraviolet detection, frequently near 214 nanometers where the peptide bond absorbs. Mass spectrometry, most often with electrospray ionization, confirms the observed molecular mass and helps separate the intact peptide from truncated or modified forms. Amino acid analysis or tandem mass spectrometry can establish residue order. Purity is commonly quoted as an area percentage, yet such values are method-dependent, and comparisons between laboratories require matching column, gradient and detection wavelength.
Proposed mechanisms centre on cell-culture observations rather than a defined receptor interaction. Several reports describe increased expression of the telomerase catalytic subunit after exposure of cultured human cells, and the authors attributed the effect to short peptide fragments entering the nucleus and influencing gene transcription. No receptor for the tetrapeptide has been identified, and the free peptide is expected to be degraded rapidly by plasma peptidases. Whether any measurable fraction reaches intact tissues after administration remains an unresolved question rather than an established finding.
The published literature is dominated by a small number of research groups, much of it in Russian-language journals, and independent replication outside those groups is limited. Studies are typically small, use cultured cells or rodent models, and report endpoints that differ between papers, which makes comparison difficult. Large randomised human trials have not appeared in the indexed literature. Questions about absorption, distribution and clearance are therefore still treated as open in reviews that mention the compound.
Epitalon is a synthetic tetrapeptide with the sequence alanine–glutamate–aspartate–glycine, commonly abbreviated AEDG. Its design traces to epithalamin, a peptide fraction prepared from bovine pineal gland extracts that researchers in Saint Petersburg began investigating in the 1970s. The compound has a molecular formula of C14H22N4O9 and a nominal molecular mass near 390 daltons. It holds no approved drug status in the United States or the European Union, and material sold under this name is generally offered as a research chemical rather than a finished pharmaceutical product.
Identity testing for epitalon relies on reversed-phase high-performance liquid chromatography for purity and mass spectrometry for mass confirmation. Because the sequence contains no tryptophan or tyrosine, ultraviolet detection at 280 nanometres is insensitive, so chromatographic methods usually monitor absorbance near 214 nanometres, where the peptide backbone absorbs. Electrospray ionisation or matrix-assisted laser desorption/ionisation then checks the intact mass against the expected value near 390 daltons. Peptide mapping or amino acid analysis after acid hydrolysis can supplement these measurements, although such confirmatory work is seldom reported on commercial certificates of analysis.
Stability of the tetrapeptide follows ordinary peptide chemistry rather than any unusual structural feature. The aspartate-glycine pair is prone to aspartimide formation under mildly basic or neutral conditions, and deamidation can follow, altering both mass and chromatographic retention. Dry lyophilised powder kept at or below minus twenty degrees Celsius is the usual handling recommendation, with repeated freeze-thaw cycles avoided. Once dissolved in neutral aqueous buffer, degradation proceeds over days to weeks depending on pH and temperature, while acidic conditions generally slow the aspartimide route. A formal stability-indicating study has not been published in the indexed literature.
Because epitalon has no pharmacopoeial monograph, quality assessment depends on supplier documentation and independent testing. Certificates of analysis typically report a purity figure from a single chromatographic run, a measured mass and sometimes an appearance description, but methods and acceptance criteria are not harmonised across vendors. Third-party laboratories can repeat identity and purity measurements, and mismatches between labelled and measured peptide content have been described for research peptides generally. What constitutes adequate identity confirmation for a molecule of this size stays an open question, since mass agreement alone does not separate closely related sequences.
A concentrate of proteolytic enzymes enriched in bromelain is approved in Europe for the debridement (removal of dead tissue) of severe burn wounds under the trade name NexoBrid. Bromelain has not been scientifically proven to be effective in treating any other diseases. Bromelain-containing dietary supplements are marketed with no confirmed efficacy, safety, recommended dosage, long term safety, or adverse interaction with other medications.
Historically, some researchers reported BAC as mass of alcohol per mass of blood (g/kg or mg/g). Because blood is slightly denser than water (about 1.05 g/mL), 1 g/L is approximately equal to 0.95 mg/g. Some countries define legal limits using mass–mass units, though public information often treats 1 liter of blood as equivalent to 1 kilogram. In pharmacokinetics, concentrations may be expressed in moles. As the molar mass of ethanol is 46.07 g/mol, a concentration of 1 g/L is equivalent to about 21.7 mmol/L (21.7 mM).
Life requires a loss of entropy, or disorder, as molecules organize themselves into living matter. At the same time, the emergence of life is associated with the formation of structures beyond a certain threshold of complexity. The emergence of life with increasing order and complexity does not contradict the second law of thermodynamics, which states that overall entropy never decreases, since a living organism creates order in some places (e.g. its living body) at the expense of an increase of entropy elsewhere (e.g. heat and waste production). Multiple sources of energy were available for chemical reactions on the early Earth. Heat from geothermal processes is a standard energy source for chemistry. Other examples include sunlight, lightning, atmospheric entries of micro-meteorites, and implosion of bubbles in sea and ocean waves. This has been confirmed by experiments and simulations. Unfavorable reactions can be driven by highly favorable ones, as in the case of iron-sulfur chemistry. For example, this was probably important for carbon fixation. Carbon fixation by reaction of CO2 with H2S via iron-sulfur chemistry is favorable, and occurs at neutral pH and 100 °C. Iron-sulfur surfaces, which are abundant near hydrothermal vents, can drive the production of small amounts of amino acids and other biomolecules.
== History == Citalopram was first synthesized in 1972 by chemist Klaus Bøgesø and his research group at the pharmaceutical company Lundbeck and was first marketed in 1989 in Denmark. It was first marketed in the US in 1998. The original patent expired in 2003, allowing other companies to legally produce and market generic versions.
Sources: en.wikipedia.org
The Riken team then repeated the original 209Bi + 70Zn reaction and produced a second atom of 278113 in April 2005, with a decay chain that again terminated with the spontaneous fission of 262Db. The decay data were slightly different from those of the first chain: this could have been because an alpha particle escaped from the detector without depositing its full energy, or because some of the intermediate decay products were formed in metastable isomeric states. In 2006, a team at the Heavy Ion Research Facility in Lanzhou, China, investigated the 243Am + 26Mg reaction, producing four atoms of 266Bh. All four chains started with an alpha decay to 262Db; three chains ended there with spontaneous fission, as in the 278113 chains observed at Riken, while the remaining one continued via another alpha decay to 258Lr, as in the 266Bh chains observed at LBNL. In June 2006, the JINR–LLNL collaboration claimed to have synthesised a new isotope of element 113 directly by bombarding a neptunium-237 target with accelerated calcium-48 nuclei:
A slow cooker (also known as a crock-pot after a trademark owned by Sunbeam Products, but sometimes used generically in the English-speaking world) is a countertop electrical cooking appliance used to simmer at a lower temperature than other cooking methods, such as baking, boiling, and frying. This facilitates unattended cooking for many hours of dishes that would otherwise be boiled, such as a pot roast, soups, stews and other dishes (including beverages, desserts and dips).
=== Differential diagnosis === Because catatonia overlaps with many psychiatric and neurological conditions a careful and detailed history, medication review, and physical exam are key to diagnosing catatonia and differentiating it from other conditions. Furthermore, some of these conditions can themselves lead to catatonia. The differential diagnosis is as follows:
Sources: en.wikipedia.org
The usual approach is reversed-phase HPLC with ultraviolet detection, reported as a percentage of total peak area. Mass spectrometry is used alongside chromatography to confirm identity rather than purity alone.
The dry powder is commonly kept at minus twenty degrees Celsius, desiccated and away from light. Solutions are generally prepared fresh because they break down faster than the solid form.
Tandem mass spectrometry or enzymatic peptide mapping can establish residue order. A single intact mass value indicates composition and molecular weight but not always the precise arrangement of residues.
The peptide contains four residues in the order alanine, glutamate, aspartate and glycine, abbreviated AEDG. The chain is linear and held together by three peptide bonds. Its calculated mass for the uncharged free form is about 390.3 daltons.