The short version of Backbone hydrolysis fits in a sentence. The long version — which is the one that helps — is below.
Reviewed 2026-07-14. Anything still debated is marked as such rather than presented as settled.
Material supplied for laboratory use is normally a lyophilised white to off-white powder that dissolves readily in water and in isotonic saline. Lyophilised cakes are hygroscopic and should be equilibrated to room temperature before opening to limit condensation on the solid. Solutions are typically prepared at milligram-per-millilitre concentrations and divided into single-use aliquots, because repeated freeze–thaw cycles degrade short peptides. Aqueous solutions are far less stable than the dry powder, and identity is usually verified by mass spectrometry alongside purity estimation from reversed-phase high-performance liquid chromatography.
Epitalon is a synthetic linear tetrapeptide with the sequence alanine–glutamate–aspartate–glycine, abbreviated AEDG. Its molecular formula is C14H22N4O9 and the calculated mass is approximately 390.35 g/mol. The compound is made by solid-phase peptide synthesis rather than extracted from tissue, although early work described it as a short fragment of a peptide fraction obtained from bovine pineal extract. In the research literature the spelling epitalon and the variant epithalone both appear, while AEDG is the standard code used in peptide nomenclature.
Several names circulate for the same molecule, including epitalon, epithalone, epithalamin tetrapeptide, and the sequence code AEDG. A CAS registry number, 307297-39-8, is commonly cited for it, though catalogue entries should be checked against supplier documentation because mislabelled records occur. In its usual form the peptide carries free amino and carboxyl termini and is neither glycosylated nor lipidated. Researchers distinguish the defined tetrapeptide from epithalamin itself, a crude pineal preparation containing many peptides that is not chemically characterised.
Identity and purity are usually assessed by reversed-phase high-performance liquid chromatography with ultraviolet detection, frequently near 214 nanometers where the peptide bond absorbs. Mass spectrometry, most often with electrospray ionization, confirms the observed molecular mass and helps separate the intact peptide from truncated or modified forms. Amino acid analysis or tandem mass spectrometry can establish residue order. Purity is commonly quoted as an area percentage, yet such values are method-dependent, and comparisons between laboratories require matching column, gradient and detection wavelength.
Laboratory handling begins with dissolution of the lyophilized powder in water or a suitable aqueous buffer. The dry solid is the more stable form, so stock solutions are generally prepared only when required and kept cold afterwards. Repeated freezing and thawing of a solution is avoided because it encourages aggregation and gradual loss of the intact chain. Diluents and containers are selected to limit adsorption of a short peptide onto plastic surfaces and to reduce microbial growth in aqueous preparations.
| Property | Value | Notes |
|---|---|---|
| Amino acid sequence | Ala-Glu-Asp-Gly | Linear tetrapeptide, also written AEDG |
| Molecular mass | About 390.35 g/mol | Value calculated from the sequence |
| Appearance | White to off-white powder | Lyophilised material forms a loose cake |
| Solubility | Freely soluble in water | Also dissolves in isotonic saline |
| Storage | -20 °C, desiccated | Aliquot solutions to avoid freeze–thaw cycling |
The compound is generally presented as a synthetic fragment of epithalamin, a pineal gland extract investigated in the former Soviet Union from the 1970s onward. Vladimir Khavinson and colleagues in Saint Petersburg developed short peptides modelled on such extracts, and epitalon became the most widely cited of those sequences. Most primary reports appeared in Russian-language journals or in proceedings with limited international circulation. Independent replication in laboratories outside that network remains sparse, and much repeated secondary material traces back to a small number of originating groups.
Laboratory work has examined effects on telomerase activity in cultured cells, on melatonin rhythms in animals, and on markers of oxidative stress. Some experiments report measurable changes while others show none, and the reported findings rest largely on small studies. The absence of large independent trials means the generality of these results is unresolved rather than settled. Review articles occasionally apply the label geroprotector, a term that reflects a research hypothesis about ageing rather than an established clinical finding.
Epitalon is the common name for a synthetic tetrapeptide with the sequence alanine-glutamate-aspartate-glycine, usually abbreviated AEDG. All four residues are proteinogenic amino acids, and the free peptide has a calculated mass near 390 grams per mole. Because the chain is short and carries no modifications, it is assembled readily by solid-phase synthesis and is distributed mainly as a freeze-dried solid for laboratory work. Catalogue listings use the spellings epitalon, epithalone, and simply AEDG, and the three refer to the same sequence.
Documentation accompanying research peptides usually includes a certificate of analysis listing the batch number, purity figure, and test methods applied. Buyers comparing suppliers should check whether the reported purity refers to chromatographic area or to a mass-balance calculation, because the two are not equivalent. Counter-ion content, residual solvents, and water content are sometimes omitted from such certificates even though they affect the actual peptide mass present. Independent verification through a second laboratory is the most direct way to confirm that a supplied material matches its label.
Purity assessment of peptide reagents normally relies on reversed-phase high-performance liquid chromatography. A gradient of acetonitrile in water with trifluoroacetic acid, paired with a C18 stationary phase, separates the target tetrapeptide from truncated sequences and deletion analogues. Detection at 214 nanometres exploits absorbance of the peptide backbone, since the molecule contains no aromatic residue. Results are expressed as a percentage of total peak area. Values above ninety-five percent are typical for research-grade material, although reporting conventions vary between suppliers.
=== Fluorescence spectroscopy === Fluorescence spectroscopy is a highly sensitive method for studying the folding state of proteins. Three amino acids, phenylalanine (Phe), tyrosine (Tyr) and tryptophan (Trp), have intrinsic fluorescence properties, but only Tyr and Trp are used experimentally because their quantum yields are high enough to give good fluorescence signals. Both Trp and Tyr are excited by a wavelength of 280 nm, whereas only Trp is excited by a wavelength of 295 nm. Because of their aromatic character, Trp and Tyr residues are often found fully or partially buried in the hydrophobic core of proteins, at the interface between two protein domains, or at the interface between subunits of oligomeric proteins. In this apolar environment, they have high quantum yields and therefore high fluorescence intensities. Upon disruption of the protein's tertiary or quaternary structure, these side chains become more exposed to the hydrophilic environment of the solvent, and their quantum yields decrease, leading to low fluorescence intensities. For Trp residues, the wavelength of their maximal fluorescence emission also depend on their environment. Fluorescence spectroscopy can be used to characterize the equilibrium unfolding of proteins by measuring the variation in the intensity of fluorescence emission or in the wavelength of maximal emission as functions of a denaturant value. The denaturant can be a chemical molecule (urea, guanidinium hydrochloride), temperature, pH, pressure, etc. The equilibrium between the different but discrete protein states, i.e.
Cardiovascular–kidney–metabolic syndrome (CKM syndrome) is a multisystem disorder of the metabolic, renal and cardiovascular systems. (The term CKM syndrome was first introduced by the American Heart Association in 2023.) This syndrome is the result of interactions between metabolic risk factors, e.g., prediabetes, type 2 diabetes, insulin resistance in normally insulin-sensitive tissues, systemic inflammation, metabolic dysfunction–associated steatotic liver disease (i.e., non-alcoholic fatty liver disease due to the accumulation of excessive fat levels in the liver), dyslipidemia, and obesity. Acting alone or interacting with each other, these abnormalities can promote chronic kidney and cardiovascular disorders and thereby lead to increases in morbidity and mortality rates.
Proteins, unlike nucleic acids, can have varying charges and complex shapes, therefore they may not migrate into the polyacrylamide gel at similar rates, or all when placing a negative to positive EMF on the sample. Proteins, therefore, are usually denatured in the presence of a detergent such as sodium dodecyl sulfate (SDS) that coats the proteins with a negative charge. Generally, the amount of SDS bound is relative to the size of the protein (usually 1.4g SDS per gram of protein), so that the resulting denatured proteins have an overall negative charge, and all the proteins have a similar charge-to-mass ratio. Since denatured proteins act like long rods instead of having a complex tertiary shape, the rate at which the resulting SDS coated proteins migrate in the gel is relative only to their size and not their charge or shape. Proteins are usually analyzed by sodium dodecyl sulfate polyacrylamide gel electrophoresis (SDS-PAGE), by blue native or clear native PAGE, by preparative native PAGE, or by 2-D electrophoresis. Characterization through ligand interaction may be performed by electroblotting or by affinity electrophoresis in agarose or by capillary electrophoresis as for estimation of binding constants and determination of structural features like glycan content through lectin binding.
Rabson–Mendenhall syndrome is a rare autosomal recessive disorder characterized by severe insulin resistance. The disorder is caused by mutations in the insulin receptor gene. Symptoms include growth abnormalities of the head, face and nails, along with the development of acanthosis nigricans. Treatment involves controlling blood glucose levels by using insulin and incorporating a strategically planned, controlled diet. Also, direct actions against other symptoms may be taken (such as surgery for facial abnormalities). Only about 50 cases have been reported and affected patients usually die during adolescence.
=== Spinal and biologics === Spinal and biologics is Medtronic's second-largest business. Medtronic is the world leader in spinal and musculoskeletal therapies. In 2007, Medtronic purchased Kyphon, a manufacturer and seller of spinal implants that are necessary for procedures like kyphoplasty. In May 2008, Medtronic Spine agreed to pay the US government $75 million to settle a qui tam lawsuit after a whistleblower alleged that Medtronic committed Medicare fraud. The company was charged with illegally convincing healthcare providers to offer kyphoplasty, a spinal fracture repair surgery, as an inpatient, not an outpatient, procedure to make thousands of dollars more in profits per surgery. A "special report" by writer Steven Brill in Time showed that according to Medtronic's quarterly SEC filing of October 2012, the company had, on average, a 75.1% profit margin on its spine products and therapies.
Sources: en.wikipedia.org
==== Thyroid ==== Given the rates of thyroid dysfunction, thyroid parameters should be checked before lithium is instituted and monitored after 3–6 months and then every 6–12 months. Thyroid stimulating hormone (TSH) levels are usually checked. The level of free thyroxine (free T4) can also be checked to detect subclinical hypothyroidism where the level of 'free T4' is low even if the level of TSH shows as normal.
Less common but more accurate and reliable is a molecular-mass-sensitive detector using multi-angle laser-light scattering - see static light scattering. These detectors directly measure the molecular mass of the polymer and are most often used in conjunction with differential refractive index detectors. A further alternative is either low-angle light scattering, which uses a single low angle to determine the molar mass, or Right-angle-light laser scattering in combination with a viscometer, although this latter technique does not give an absolute measure of molar mass but one relative to the structural model used. The molar mass distribution of a polymer sample depends on factors such as chemical kinetics and work-up procedure. Ideal step-growth polymerization gives a polymer with dispersity of 2. Ideal living polymerization results in a dispersity of 1. By dissolving a polymer an insoluble high molar mass fraction may be filtered off resulting in a large reduction in Mw and a small reduction in Mn, thus reducing dispersity.
== Neutrophil-activating peptide 2 == Neutrophil-activating peptide 2 (NAP-2) is a chemokine that corresponds to positions 59-128 of PPBP. NAP-2 activates and attracts neutrophils through interaction with the receptors CXCR1 and CXCR2. There are also shorter (and longer) versions of this peptide with similar effects, with NAP-2(1-63) (corresponding to positions 59-121 of PPBP) being the most potent.
Excess 129Xe found in carbon dioxide well gases from New Mexico was believed to be from the decay of mantle-derived gases soon after Earth's formation. It has been suggested that the isotopic composition of atmospheric xenon fluctuated prior to the GOE before stabilizing, perhaps as a result of the rise in atmospheric O2.
Sources: en.wikipedia.org
==== Railway ==== With the opening of the railway from London to Liverpool, Holyhead lost the London-Dublin mail contract in 1839 to the Port of Liverpool. Only after the completion of the Chester and Holyhead Railway in 1850, and the building of Holyhead railway station, did the Irish Mail return to Holyhead, operated from London Euston by the London and North Western Railway.
=== Pseudobulbar affect === Pseudobulbar affect (PBA) is a condition involving episodic uncontrollable laughter or crying. PBA mostly occurs in people with neurological injuries affecting how the brain controls emotions. Scientists believe PBA results from prefrontal cortex damage. PBA often involves crying. Hence, PBA is mistakable for depression. But PBA is neurological; depression is psychological. Patients with PBA do not experience typical depression symptoms like sleep disturbances or appetite loss.
The first was neoprene, a synthetic rubber widely used during World War II. The second was an elastic paste that became very strong upon cooling; this would later become nylon. After these discoveries, Carothers' team was made to shift its research from a more pure research approach investigating general polymerization to a more practically focused goal of finding "one chemical combination that would lend itself to industrial applications". It was not until the beginning of 1935 that a polymer called "polymer 6-6" was finally produced. Carothers' coworker, Washington University alumnus Julian W. Hill had used a cold drawing method to produce a polyester in 1930. This cold drawing method was later used by Carothers in 1935 to fully develop nylon. The first example of nylon (nylon 6.6) was produced on February 28, 1935, at DuPont's research facility at the DuPont Experimental Station. It had all the desired properties of elasticity and strength. However, it also required a complex manufacturing process that would become the basis of industrial production in the future. DuPont obtained a patent for the polymer in September 1938, and quickly achieved a monopoly of the fiber. Carothers died 16 months before the announcement of nylon, therefore he was never able to see his success. The name "Nylon" came from the modification of norun (no run) into a unique name that could be used to market the product but was not trademarked.
Sources: en.wikipedia.org
It is a synthetic tetrapeptide. Its sequence was derived from research on peptide fractions of bovine pineal extract, and the intact AEDG sequence has not been demonstrated as an abundant free peptide in human tissue.
AEDG is the one-letter code for the four amino acids alanine, glutamate, aspartate and glycine in that order. The same molecule is written in three-letter form as Ala-Glu-Asp-Gly.
Identity is normally confirmed by mass spectrometry against the calculated mass of roughly 390.35 g/mol. Purity is then estimated by reversed-phase high-performance liquid chromatography with ultraviolet detection.
The dry powder is typically held at -20 degrees Celsius or lower, protected from light and moisture. Allowing a sealed vial to reach room temperature before opening reduces condensation on its contents. Conditions stated on a supplier certificate of analysis take precedence over general guidance.