pineal peptides is one of those subjects where the details matter more than the headlines. This page pulls together the background, the mechanisms, and the practical points readers ask about most.
Last reviewed on 2026-08-01. Where a claim depends on a specific study, the study is described rather than over-claimed.
Residue composition is the property that most cleanly separates verified material from mislabelled samples. Alanine, glutamate, aspartate and glycine appear in that order from the N-terminus, and the two acidic residues sit in the middle of the chain. Because the peptide is short, it can be produced by solid-phase synthesis and characterised by mass spectrometry without ambiguity. Any reported sample whose measured mass departs substantially from 390 daltons is a different compound or a degraded mixture rather than epitalon.
Epitalon is a synthetic tetrapeptide whose four residues are alanine, glutamate, aspartate and glycine, commonly abbreviated AEDG. Its molecular formula is C14H22N4O9 and its monoisotopic mass is near 390.35 daltons. The peptide carries two acidic side chains, so it is neutral to negatively charged in most aqueous buffers. Published reference summaries usually list it under both spellings, epitalon and epithalon, and treat the two names as the same material.
Identity and purity are established with reversed-phase high-performance liquid chromatography and mass spectrometry. The chromatogram shows the main peak and any truncated or oxidised by-products, while the mass spectrum confirms the expected 390 dalton mass. Amino acid analysis can corroborate composition when a sample's origin is uncertain. Counterion content, particularly residual trifluoroacetate from purification, is frequently reported alongside purity because it shifts the net mass of the solid.
Reference material is normally supplied as a lyophilised powder in a sealed vial. Product literature typically recommends storage at minus twenty degrees Celsius or colder, protected from light and moisture. Freeze-thaw cycling is usually avoided because repeated condensation can introduce water into the vial. Working solutions are commonly prepared fresh, aliquoted, and kept cold for short periods rather than stored at ambient temperature. Labelling the date of opening helps track how long a vial has been in use.
| Property | Value | Notes |
|---|---|---|
| Molecular formula | C14H22N4O9 | Derived from the four constituent residues |
| Molecular mass | About 390.35 Da | Monoisotopic value, confirmed by mass spectrometry |
| Residue sequence | Ala-Glu-Asp-Gly | Read from the N-terminus to the C-terminus |
| Common synonyms | Epithalon; AEDG | Both forms appear in reference catalogues |
| Net charge near neutral pH | Negative | Two acidic side chains give a low isoelectric point |
The compound is generally presented as a synthetic fragment of epithalamin, a pineal gland extract investigated in the former Soviet Union from the 1970s onward. Vladimir Khavinson and colleagues in Saint Petersburg developed short peptides modelled on such extracts, and epitalon became the most widely cited of those sequences. Most primary reports appeared in Russian-language journals or in proceedings with limited international circulation. Independent replication in laboratories outside that network remains sparse, and much repeated secondary material traces back to a small number of originating groups.
Laboratory work has examined effects on telomerase activity in cultured cells, on melatonin rhythms in animals, and on markers of oxidative stress. Some experiments report measurable changes while others show none, and the reported findings rest largely on small studies. The absence of large independent trials means the generality of these results is unresolved rather than settled. Review articles occasionally apply the label geroprotector, a term that reflects a research hypothesis about ageing rather than an established clinical finding.
Epitalon is the common name for a synthetic tetrapeptide with the sequence alanine-glutamate-aspartate-glycine, usually abbreviated AEDG. All four residues are proteinogenic amino acids, and the free peptide has a calculated mass near 390 grams per mole. Because the chain is short and carries no modifications, it is assembled readily by solid-phase synthesis and is distributed mainly as a freeze-dried solid for laboratory work. Catalogue listings use the spellings epitalon, epithalone, and simply AEDG, and the three refer to the same sequence.
Short peptides such as AEDG are normally supplied as a freeze-dried solid and are kept dry, cold, and shielded from light. Holding at minus twenty degrees Celsius is common for the long term, while a refrigerator suffices for brief periods before use. The material takes up moisture to some degree, so containers should stay sealed and be allowed to reach room temperature before opening, which limits condensation on the contents. Repeated warming and cooling of a single container is discouraged because it admits water and can lower the amount of intact peptide.
Dissolution is usually performed in water or a suitable aqueous buffer, and the resulting liquid is divided into single-use portions before freezing. Freeze-thaw cycling is a recognised source of loss for short peptides, since each cycle can encourage aggregation or adsorption onto container walls. Working solutions are generally kept cold and used within a short window, although published stability data specific to epitalon are thin. Containers should be marked with concentration and date, and solutions examined for cloudiness before use.
Epitalon is a synthetic four-amino-acid peptide with the sequence alanine-glutamate-aspartate-glycine, commonly abbreviated AEDG. Its molecular formula is C14H22N4O9, and its calculated molar mass is approximately 390.35 grams per mole. The compound is a short fragment related to a peptide fraction isolated from bovine pineal gland extracts, and it is normally supplied as a lyophilised powder intended for laboratory research. It is not a registered pharmaceutical product in most countries.
The peptide emerged from research carried out in Saint Petersburg from the late 1980s onward, where investigators searched for shorter active fragments of a pineal preparation known as epithalamin. The name epitalon was chosen to reflect that parent extract. Early reports described effects on neuroendocrine markers and on the lifespan of laboratory animals. Much of that work appeared in Russian-language journals, with English translations following later, which affects how readily the original protocols can be assessed by outside groups.
Published studies on epitalon are dominated by a small number of research groups, and independent replication in other laboratories remains limited. Proposed mechanisms include activation of telomerase and modulation of melatonin rhythms, but the evidence for either rests mainly on cell cultures and animal models. Whether the peptide produces comparable effects in humans is an open question, and the absence of large controlled trials means the literature is best read as exploratory rather than settled.
Identity and purity of epitalon samples are normally established by reversed-phase high-performance liquid chromatography with ultraviolet detection near 214 nanometres, combined with mass spectrometry. The mass spectrum confirms the expected molecular ion and can reveal truncated or oxidised by-products. Amino acid analysis after acid hydrolysis verifies that the four residues are present in the expected ratio. Certificates typically report a purity figure taken from chromatographic peak area, expressed as a percentage of total integrated signal.
Lyophilised epitalon is generally held at minus twenty degrees Celsius in a sealed container kept dry and dark. Cooler conditions are sometimes recommended for long-term archives. The solid takes up moisture readily enough that repeated opening of a vial introduces water, so dividing a batch into smaller portions before storage lowers degradation risk. Aqueous solutions are less durable than the dry powder and are usually prepared shortly before use, then kept cold and shielded from light to slow hydrolysis and oxidation.
=== Experimental application === As described in the applications section, spectrophotometry can be used in both qualitative and quantitative analysis of DNA, RNA, and proteins. Qualitative analysis can be used and spectrophotometers are used to record spectra of compounds by scanning broad wavelength regions to determine the absorbance properties (the intensity of the color) of the compound at each wavelength. One experiment that can demonstrate the various uses that visible spectrophotometry can have is the separation of β-galactosidase from a mixture of various proteins. Largely, spectrophotometry is best used to help quantify the amount of purification your sample has undergone relative to total protein concentration. By running an affinity chromatography, B-Galactosidase can be isolated and tested by reacting collected samples with Ortho-Nitrophenyl-β-galactoside (ONPG) and determining if the sample turns yellow. Following this testing the sample at 420 nm for specific interaction with ONPG and at 595 for a Bradford Assay the amount of purification can be assessed quantitatively. In addition to this spectrophotometry can be used in tandem with other techniques such as SDS-Page electrophoresis in order to purify and isolate various protein samples.
She has highlighted concerns including excessive hype around these drugs, questionable biologically-based theories of benefit, blurred lines between medical and recreational use, flawed clinical trial findings, financial conflicts of interest, strong expectancy effects and large placebo responses, small and short-term benefits over placebo, and their potential for difficult and potentially destabilizing experiences and adverse effects, among others.
=== Hydrophilic - Lipophilic Balance === This part of the article aims at disambiguating of the notion of HLB, "Hydrophile - Lipophile Balance", attributed to Sucrose Fatty Acid Ester surfactants (also named sucrose esters or sugar esters). The attribution of HLB values to sucrose esters emulsifiers at the origin is unclear, since no bibliographic source can be found on how the attribution has been made. There is no early scientific data, dating back to the 1990s or earlier, supporting experimentally the current HLB scale attributed to sucrose esters. However, a clear numerical correlation is found between the Griffin HLB scale defined for non-ionic poly(ethylene oxide) (PEO) surfactants and the HLB scale attributed to marketed sucrose esters. For polyethylene oxide non ionic surfactants the HLB is defined by the Griffin's scale (Equation 1):
With their repeated –CH2 units, the alkanes constitute a homologous series of organic compounds in which the members differ in molecular mass by multiples of 14.03 u (the total mass of each such methylene bridge unit, which comprises a single carbon atom of mass 12.01 u and two hydrogen atoms of mass ~1.01 u each). Methane is produced by methanogenic archaea and some long-chain alkanes function as pheromones in certain animal species or as protective waxes in plants and fungi. Nevertheless, most alkanes do not have much biological activity. They can be viewed as molecular trees upon which can be hung the more active/reactive functional groups of biological molecules. The alkanes have two main commercial sources: petroleum (crude oil) and natural gas. An alkyl group is an alkane-based molecular fragment that bears one open valence for bonding. They are generally abbreviated with the symbol for any organyl group, R, although Alk is sometimes used to specifically symbolize an alkyl group (as opposed to an alkenyl group or aryl group).
== Lubrication == Many driving chains (for example, in factory equipment, or driving a camshaft inside an internal combustion engine) operate in clean environments, and thus the wearing surfaces (that is, the pins and bushings) are safe from precipitation and airborne grit, many even in a sealed environment such as an oil bath. Some roller chains are designed to have o-rings built into the space between the outside link plate and the inside roller link plates. Chain manufacturers began to include this feature in 1971 after the application was invented by Joseph Montano while working for Whitney Chain of Hartford, Connecticut. O-rings were included as a way to improve lubrication to the links of power transmission chains, a service that is vitally important to extending their working life. These rubber fixtures form a barrier that holds factory applied lubricating grease inside the pin and bushing wear areas. Further, the rubber o-rings prevent dirt and other contaminants from entering inside the chain linkages, where such particles would otherwise cause significant wear. There are also many chains that have to operate in dirty conditions, and for size or operational reasons cannot be sealed. Examples include chains on farm equipment, bicycles, and chain saws. These chains will necessarily have relatively high rates of wear. Many oil-based lubricants attract dirt and other particles, eventually forming an abrasive paste that will compound wear on chains.
Sources: en.wikipedia.org
=== Mexico === The Secretariat of National Defense issues the "Individual Soldiers Daily Combat Meal" box (Spanish: Ración Diaria Individual de Combate). It is packaged in an olive green and black plastic box with the contents printed on the front; the box contains three individual meal packs containing meals providing 3,640 to 4,030 kcal (15,200 to 16,900 kJ) which are meant to sustain a soldier for one day. Each individual meal package contains two main retort pouches which are meant to be eaten with each other. The first retort pouch usually contains a meat product (such as beef, pork, sausage, fish, ham, seafood, chicken, tuna, bacon, or other meats which are usually mixed with a flavoring sauce and vegetables) the second retort pouch contains a staple food (rice, hominy, noodles, beans, pasta, eggs, or more vegetables). Each meal package also contains salt, spices, condensed milk, cream, butter, chorizo spread, dried fruit or preserves, bread, crackers, sugar, custard, cookies, canned fish, cocoa mix, nuts, chocolate or other candies, vitamins, a large pouch of drinking water, a pouch of Jumex fruit juice or Coca-Cola, biodegradable napkins and utensils, and water purification tablets. Some meal packages do not contain the two main retort pouches and instead contain a single larger pouch with a finished meal such as tamales or steak and eggs but, these are usually only available when close to a base or when the military is operating in an urban area.
It is commonly used in lieu of boric acid and can be used to help control and possibly eliminate bed bugs, house dust mite, cockroach, ant, and flea infestations. Diatomaceous earth is widely applied for insect control in grain storage. It is used to control cannibalistic behaviors in confused flour beetles, which infest flour storages. To be effective as an insecticide, diatomaceous earth must have a mean particle size below about 12 μm (i.e., food grade—see below); and it must be uncalcinated (i.e., it must not be heat-treated prior to application). Although considered to be relatively low-risk, pesticides containing diatomaceous earth are not exempt from regulation in the United States under the Federal Insecticide, Fungicide, and Rodenticide Act and must be registered with the Environmental Protection Agency.
In the summer of 1645, Royalist forces were defeated by the New Model Army at the Battle of Langport, in Somerset. Following further victories at Bridgwater and Sherborne, Sir Thomas Fairfax marched on Bristol. Prince Rupert returned to organise the defence of the city. The Parliamentary forces besieged the city and after three weeks attacked, eventually forcing Rupert to surrender on 10 September. The First Civil War ended the following year. There were no further military actions in Bristol during the second and third civil wars. In 1656, Oliver Cromwell ordered the destruction of the castle.
Expression of foreign proteins requires the use of specialized expression vectors and often necessitates significant restructuring by foreign coding sequences. Recombinant DNA differs from genetic recombination in that the former results from artificial methods while the latter is a normal biological process that results in the remixing of existing DNA sequences in essentially all organisms.
Sources: en.wikipedia.org
It is a four-amino-acid peptide built from alanine, glutamate, aspartate and glycine in that order. Its formula is C14H22N4O9, and it is made by chemical synthesis rather than extracted from tissue. The synthetic peptide is a single defined molecule, unlike the pineal extracts it is often compared with.
No. The two spellings refer to the same tetrapeptide, and the difference reflects transliteration from Russian. Laboratories and catalogues use both forms interchangeably. The material is also indexed as AEDG, taken from the one-letter codes of its residues.
Epithalamin is a mixed preparation derived from animal pineal tissue and contains many peptides. Epitalon is one synthetic sequence chosen for study from that broader mixture. Statements about one do not transfer directly to the other.
Sealed lyophilised powder is normally kept at minus twenty degrees Celsius or below, away from light and moisture. Vials are allowed to reach room temperature before opening to limit condensation. Repeated warming and cooling of the same vial is discouraged.