Khavinson is one of those subjects where the details matter more than the headlines. This page pulls together the background, the mechanisms, and the practical points readers ask about most.
Updated 2026-05-12. Numbers and descriptions here follow the published literature rather than marketing material.
Laboratory-grade epitalon is typically supplied as a lyophilized powder. Purity is commonly assessed with reverse-phase high-performance liquid chromatography, often paired with mass spectrometry to confirm molecular identity. Amino acid analysis and peptide mapping can provide additional confirmation of sequence. Certificates of analysis for research materials frequently report purity above 95 percent, although the methods behind such figures vary between suppliers. The absence of a pharmacopeial monograph means that no single standardized assay defines the compound, so reported results depend on the analytical protocol chosen.
Storage recommendations center on limiting moisture, heat, and light. The dry powder is generally kept at minus 20 degrees Celsius, and some suppliers recommend minus 80 degrees for long-term archival. Once dissolved, solutions are usually aliquoted and frozen to avoid repeated freeze-thaw cycles, which can promote aggregation or degradation. Aqueous stability depends on pH and concentration, and buffered saline is often preferred over plain water for biological work. Stability data specific to epitalon remain limited, so general peptide-handling practices are applied by analogy rather than from product-specific validation.
Identity testing for epitalon relies on reversed-phase high-performance liquid chromatography for purity and mass spectrometry for mass confirmation. Because the sequence contains no tryptophan or tyrosine, ultraviolet detection at 280 nanometres is insensitive, so chromatographic methods usually monitor absorbance near 214 nanometres, where the peptide backbone absorbs. Electrospray ionisation or matrix-assisted laser desorption/ionisation then checks the intact mass against the expected value near 390 daltons. Peptide mapping or amino acid analysis after acid hydrolysis can supplement these measurements, although such confirmatory work is seldom reported on commercial certificates of analysis.
Stability of the tetrapeptide follows ordinary peptide chemistry rather than any unusual structural feature. The aspartate-glycine pair is prone to aspartimide formation under mildly basic or neutral conditions, and deamidation can follow, altering both mass and chromatographic retention. Dry lyophilised powder kept at or below minus twenty degrees Celsius is the usual handling recommendation, with repeated freeze-thaw cycles avoided. Once dissolved in neutral aqueous buffer, degradation proceeds over days to weeks depending on pH and temperature, while acidic conditions generally slow the aspartimide route. A formal stability-indicating study has not been published in the indexed literature.
Because epitalon has no pharmacopoeial monograph, quality assessment depends on supplier documentation and independent testing. Certificates of analysis typically report a purity figure from a single chromatographic run, a measured mass and sometimes an appearance description, but methods and acceptance criteria are not harmonised across vendors. Third-party laboratories can repeat identity and purity measurements, and mismatches between labelled and measured peptide content have been described for research peptides generally. What constitutes adequate identity confirmation for a molecule of this size stays an open question, since mass agreement alone does not separate closely related sequences.
| Property | Value | Notes |
|---|---|---|
| Molecular formula | C14H22N4O9 | Free acid form of the tetrapeptide |
| Molecular mass | About 390.35 Da | Calculated monoisotopic value |
| Appearance | White to off-white powder | Typical lyophilized presentation |
| Solubility | Soluble in water | Also dissolves in buffered saline |
| Storage temperature | Minus 20 degrees Celsius | Dry, dark conditions; avoid repeated thawing |
Epitalon is the common name for a synthetic tetrapeptide with the sequence alanine-glutamate-aspartate-glycine, usually abbreviated AEDG. All four residues are proteinogenic amino acids, and the free peptide has a calculated mass near 390 grams per mole. Because the chain is short and carries no modifications, it is assembled readily by solid-phase synthesis and is distributed mainly as a freeze-dried solid for laboratory work. Catalogue listings use the spellings epitalon, epithalone, and simply AEDG, and the three refer to the same sequence.
The compound is generally presented as a synthetic fragment of epithalamin, a pineal gland extract investigated in the former Soviet Union from the 1970s onward. Vladimir Khavinson and colleagues in Saint Petersburg developed short peptides modelled on such extracts, and epitalon became the most widely cited of those sequences. Most primary reports appeared in Russian-language journals or in proceedings with limited international circulation. Independent replication in laboratories outside that network remains sparse, and much repeated secondary material traces back to a small number of originating groups.
Laboratory work has examined effects on telomerase activity in cultured cells, on melatonin rhythms in animals, and on markers of oxidative stress. Some experiments report measurable changes while others show none, and the reported findings rest largely on small studies. The absence of large independent trials means the generality of these results is unresolved rather than settled. Review articles occasionally apply the label geroprotector, a term that reflects a research hypothesis about ageing rather than an established clinical finding.
The molecule is a short, linear, hydrophilic peptide that dissolves readily in water or aqueous buffer. Its principal chemical liabilities are hydrolytic rather than oxidative, since it contains no cysteine, methionine, or tryptophan residues. The aspartate–glycine step is a recognised site for aspartimide formation under mildly acidic or basic conditions, generating isoaspartate and succinimide-related products over time. Desiccated lyophilised powder held at −20 °C is comparatively stable, whereas dilute solutions degrade faster and are best frozen as single-use aliquots rather than thawed repeatedly.
No pharmacopoeial monograph exists for this peptide, so quality rests on the supplier's internal specifications and on whatever independent testing a purchaser arranges. Certificates of analysis differ widely in which tests they report and in the limits applied. The counter-ion introduced during purification, commonly acetate or trifluoroacetate, changes the net peptide content of a given mass of powder, so two samples of equal weight may not contain equal amounts of the active sequence. Third-party laboratories can verify purity, identity, residual solvents, and counter-ion content for a fee, which makes documentation more informative than labelling.
=== Former commissioners === David Gallop was the initial chief executive officer of the restructured ARL Commission. He was previously the CEO of the NRL and his contract extension to become inaugural ARL CEO was a condition placed by News Limited with the ARL. On 5 June 2012 the ARL announced Gallop's departure from the CEO position and that he would take up a position at the FFA in 2013. David Smith was announced as the new ARL CEO in November 2012, taking charge on 1 February 2013.
Most of the spectroscopy methods: ultraviolet–visible spectroscopy, infrared spectroscopy, nuclear magnetic resonance, X-ray fluorescence, Energy-dispersive X-ray spectroscopy, Wavelength-dispersive X-ray spectroscopy, and mass spectrometry Most of the chromatography methods : high-performance liquid chromatography, Gel permeation chromatography; Some thermal analysis methods: differential scanning calorimetry, thermogravimetric analysis; Electrophoresis; Field flow fractionation; X-ray diffraction; Combustion analysis.
Tarichatoxin was shown to be identical to TTX in 1964 by Mosher et al., and the identity of maculotoxin and TTX was reported in Science in 1978, and the synonymity of these two toxins is supported in modern reports (e.g., at Pubchem and in modern toxicology textbooks) though historic monographs questioning this continue in reprint. The toxin is variously used by animals as a defensive biotoxin to ward off predation, or as both a defensive and predatory venom (e.g., in octopuses, chaetognaths, and ribbon worms). Even though the toxin acts as a defense mechanism, some predators such as the common garter snake have developed insensitivity to TTX, which allows them to prey upon toxic newts. The association of TTX with consumed, infecting, or symbiotic bacterial populations within the animal species from which it is isolated is relatively clear; presence of TTX-producing bacteria within an animal's microbiome is determined by culture methods, the presence of the toxin by chemical analysis, and the association of the bacteria with TTX production by toxicity assay of media in which suspected bacteria are grown. As Lago et al. note, "there is good evidence that uptake of bacteria producing TTX is an important element of TTX toxicity in marine animals that present this toxin." TTX-producing bacteria include Actinomyces, Aeromonas, Alteromonas, Bacillus, Pseudomonas, and Vibrio species; in the following animals, specific bacterial species have been implicated:
Sources: en.wikipedia.org
Some of the multiple activities of thymosin β4 unrelated to actin may be mediated by a tetrapeptide enzymically cleaved from its N-terminus, N-acetyl-ser-asp-lys-pro, brand names Seraspenide or Goralatide, best known as an inhibitor of the proliferation of haematopoietic (blood-cell precursor) stem cells of bone marrow.
Barbiturates Benzodiazepines Ethanol (drinking alcohol; ethyl alcohol) Nonbenzodiazepines Others carisoprodol (Soma) chloral hydrate diethyl ether ethchlorvynol (Placidyl; "jelly-bellies") gamma-butyrolactone (GBL, a prodrug to GHB) gamma-hydroxybutyrate (GHB; G; Xyrem; "Liquid Ecstasy", "Fantasy") glutethimide (Doriden) kava (from Piper methysticum; contains kavalactones) ketamine, a phencyclidine (PCP) analog meprobamate (Miltown) methaqualone (Sopor, Mandrax; "Quaaludes") phenibut propofol (Diprivan), a general anesthetic theanine (found in Camellia sinensis, the tea plant) valerian (from Valeriana officinalis)
Restricting the use of foamed polystyrene takeout food packaging is a priority of many solid waste environmental organisations. Efforts have been made to find alternatives to polystyrene, especially foam in restaurant settings. The original impetus was to eliminate chlorofluorocarbons (CFC), which was a former component of foam.
Sources: en.wikipedia.org
Epitalon is a synthetic tetrapeptide built from four amino acids: alanine, glutamate, aspartate, and glycine. It is not extracted from a natural source but made in the laboratory by chemical synthesis. Its short length makes it relatively straightforward to produce at high purity.
No naturally occurring free form of the peptide has been described. The four-amino-acid sequence can appear as a fragment within larger proteins, but that is not the same as the intact compound being present as a circulating molecule. Materials used in research are synthetic.
Purity is usually checked by reverse-phase high-performance liquid chromatography, which separates the target peptide from related impurities. Mass spectrometry is commonly used alongside it to confirm molecular mass. Some suppliers also provide amino acid analysis for additional sequence confirmation.
The molecule lacks aromatic residues, so it absorbs weakly near 280 nanometres, the wavelength applied to many other peptides. The peptide bond absorbs strongly below 220 nanometres, making 214 nanometres a practical compromise. Gradient methods must therefore use mobile phases with low ultraviolet absorbance to keep the baseline clean.