en · de · es
lab-handbook.peptides9000.com › Topic › Peptide Identity And Laboratory Handling — Quick Reference

Peptide Identity And Laboratory Handling — Quick Reference

By Editorial Desk · published 2025-12-16 · last reviewed 2026-01-24 · Topic

This is a working overview of Tetrapeptide, written for readers who want more than a one-paragraph summary but less than a textbook.

Reviewed 2026-01-24. Anything still debated is marked as such rather than presented as settled.

Peptide Identity and Laboratory Handling

Epitalon is a synthetic tetrapeptide with the sequence alanine-glutamate-aspartate-glycine, abbreviated AEDG. Its molecular formula is C14H22N4O9 and its calculated monoisotopic mass is approximately 390.35 daltons. The compound does not occur naturally as a free peptide; it is produced by solid-phase peptide synthesis. Because it contains two acidic residues and no basic residues, the neutral form carries a net negative charge at physiological pH. This charge profile influences how the peptide behaves in solution and during chromatographic analysis.

Laboratory-grade epitalon is typically supplied as a lyophilized powder. Purity is commonly assessed with reverse-phase high-performance liquid chromatography, often paired with mass spectrometry to confirm molecular identity. Amino acid analysis and peptide mapping can provide additional confirmation of sequence. Certificates of analysis for research materials frequently report purity above 95 percent, although the methods behind such figures vary between suppliers. The absence of a pharmacopeial monograph means that no single standardized assay defines the compound, so reported results depend on the analytical protocol chosen.

Storage recommendations center on limiting moisture, heat, and light. The dry powder is generally kept at minus 20 degrees Celsius, and some suppliers recommend minus 80 degrees for long-term archival. Once dissolved, solutions are usually aliquoted and frozen to avoid repeated freeze-thaw cycles, which can promote aggregation or degradation. Aqueous stability depends on pH and concentration, and buffered saline is often preferred over plain water for biological work. Stability data specific to epitalon remain limited, so general peptide-handling practices are applied by analogy rather than from product-specific validation.

Structure, Naming and Discovery

Epitalon is a synthetic tetrapeptide whose four residues are alanine, glutamate, aspartate and glycine, commonly abbreviated AEDG. Its molecular formula is C14H22N4O9 and its monoisotopic mass is near 390.35 daltons. The peptide carries two acidic side chains, so it is neutral to negatively charged in most aqueous buffers. Published reference summaries usually list it under both spellings, epitalon and epithalon, and treat the two names as the same material.

The compound is generally described as a synthetic analogue of a fragment isolated from a pineal gland extract. Researchers associated with the Saint Petersburg Institute of Bioregulation and Gerontology introduced it during the 1980s and 1990s while studying short peptides from animal tissue. The original extract, called epithalamin, is a heterogeneous mixture, whereas epitalon is a single defined sequence. That distinction matters because findings reported for the extract are not automatically findings about the pure tetrapeptide, and claims about broader biological effects remain a separate question from the chemical identity described here.

Epitalon at a glance

PropertyValueNotes
Molecular formulaC14H22N4O9Free acid form of the tetrapeptide
Molecular massAbout 390.35 DaCalculated monoisotopic value
AppearanceWhite to off-white powderTypical lyophilized presentation
SolubilitySoluble in waterAlso dissolves in buffered saline
Storage temperatureMinus 20 degrees CelsiusDry, dark conditions; avoid repeated thawing

Peptide Identity and Research Origin

Epitalon is a synthetic tetrapeptide with the sequence alanine–glutamate–aspartate–glycine, commonly abbreviated AEDG. Its design traces to epithalamin, a peptide fraction prepared from bovine pineal gland extracts that researchers in Saint Petersburg began investigating in the 1970s. The compound has a molecular formula of C14H22N4O9 and a nominal molecular mass near 390 daltons. It holds no approved drug status in the United States or the European Union, and material sold under this name is generally offered as a research chemical rather than a finished pharmaceutical product.

Proposed mechanisms centre on cell-culture observations rather than a defined receptor interaction. Several reports describe increased expression of the telomerase catalytic subunit after exposure of cultured human cells, and the authors attributed the effect to short peptide fragments entering the nucleus and influencing gene transcription. No receptor for the tetrapeptide has been identified, and the free peptide is expected to be degraded rapidly by plasma peptidases. Whether any measurable fraction reaches intact tissues after administration remains an unresolved question rather than an established finding.

Related pages on this site

Background from the literature

The following figures were averaged from 2005 to 2007 adult data compiled by the CDC BRFSS program and 2003–2004 child data[A] from the National Survey of Children's Health. There is also data from a more recent 2016 CDC study of the 50 states plus the District of Columbia, Puerto Rico, the U.S. Virgin Islands and Guam. Care should be taken in interpreting these numbers, because they are based on self-report surveys which asked individuals (or, in case of children and adolescents, their parents) to report their height and weight. Height is commonly overreported and weight underreported, sometimes resulting in significantly lower estimates. One study estimated the difference between actual and self-reported obesity as 7% among males and 13% among females as of 2002, with the tendency to increase. The long-running REGARDS study, published in the journal of Obesity in 2014, brought in individuals from the nine census regions and measured their height and weight. The data collected disagreed with the data in the CDC's phone survey used to create the following chart. REGARDS found that the West North Central region (North Dakota, South Dakota, Minnesota, Missouri, Nebraska, and Iowa), and East North Central region (Illinois, Ohio, Wisconsin, Michigan, and Indiana) were the worst in obesity numbers, not the East South Central region (Tennessee, Mississippi, Alabama, Kentucky) as had been previously thought. Dr.

=== Liquid chromatography-liquid chromatography === Two-dimensional liquid chromatography (2D-LC) combines two separate analyses of liquid chromatography into one data analysis. Modern 2D liquid chromatography has its origins in the late 1970s to early 1980s. During this time, the hypothesized principles of 2D-LC were being proven via experiments conducted along with supplementary conceptual and theoretical work. It was shown that 2D-LC could offer quite a bit more resolving power compared to the conventional techniques of one-dimensional liquid chromatography. In the 1990s, the technique of 2D-LC played an important role in the separation of extremely complex substances and materials found in the proteomics and polymer fields of study. Unfortunately, the technique had been shown to have a significant disadvantage when it came to analysis time. Early work with 2D-LC was limited to small portion of liquid phase separations due to the long analysis time of the machinery. Modern 2D-LC techniques tackled that disadvantage head on, and have significantly reduced what was once a damaging feature. Modern 2D-LC has an instrumental capacity for high resolution separations to be completed in an hour or less. Due to the growing need for instrumentation to perform analysis on substances of growing complexity with better detection limits, the development of 2D-LC pushes forward. Instrumental parts have become a mainstream industry focus and are much easier to attain then before.

This characteristic distinguishes the C5 step, along with the C2 step, as potentially rate-limiting in the complement reaction. However, unlike C2, C5 remains firmly cell-bound during the decay process and apparently undergoes an alteration in situ which renders it hemolyticly unreactive. Finally, C5 is unique in that it readily adsorbs in native form to unsensitized erythrocytes. This nonspecifically bound C5 remains firmly attached, although it may be specifically utilized as a source of C5 by an ongoing complement reaction.

Sources: en.wikipedia.org

Reference notes

Sinusoidal capillaries or discontinuous capillaries are a special type of open-pore capillary, also known as a sinusoid, that have wider fenestrations that are 30–40 micrometres (μm) in diameter, with wider openings in the endothelium. Fenestrated capillaries have diaphragms that cover the pores whereas sinusoids lack a diaphragm and just have an open pore. These types of blood vessels allow red and white blood cells (7.5 μm – 25 μm diameter) and various serum proteins to pass, aided by a discontinuous basal lamina. These capillaries lack pinocytotic vesicles, and therefore use gaps present in cell junctions to permit transfer between endothelial cells, and hence across the membrane. Sinusoids are irregular spaces filled with blood and are mainly found in the liver, bone marrow, spleen, and brain circumventricular organs.

=== Acidity === The C9–H sites of the fluorene ring are weakly acidic (pKa = 22.6 in DMSO). Deprotonation gives the stable fluorenyl anion, nominally C13H−9, which is aromatic and has an intense orange colour. The anion is a nucleophile. Electrophiles react with it by adding to the 9-position. The purification of fluorene exploits its acidity and the low solubility of its sodium derivative in hydrocarbon solvents. Both protons can be removed from C9. For example, 9,9-fluorenyldipotassium can be obtained by treating fluorene with potassium metal in boiling dioxane.

Frugivorous bats lack that ability and have kidneys adapted for electrolyte retention due to their low-electrolyte diet; their kidneys accordingly have a thick cortex and very short conical papillae. Flying gives bats relatively high metabolism, which increases respiratory water loss. Lipids known as cerebrosides retain water in cold temperatures but allow for evaporation through the skin in hot temperatures to cool them. Water helps maintain the ionic balance in their blood, thermoregulation system and urinary and waste system. They are also susceptible to blood urea poisoning if they do not receive enough fluid. The structure of the uterine system in female bats can vary by species, with some having two uterine horns while others have a single mainline chamber.

Sources: en.wikipedia.org

Notes from published material

== BOLD-100 derivatives == BOLD-100 is sodium trans-[tetrachlorobis (1H-indazole) ruthenate(III)] with cesium as an intermediate salt form. BOLD-100 was developed from KP1339 (also known as IT-139 or NKP-1339) which is also sodium trans-[tetrachlorobis (1H-indazole) ruthenate(III)], but has different manufacturing methods and purity profiles. The names are often used interchangeably. The precursor to BOLD-100 is KP1019, which is the indazole salt equivalent. KP1019 previously entered Phase 1 clinical trials but development was halted due to low solubility in water, leading to the development of KP1339 and BOLD-100 which are readily soluble in water. KP1019 and KP1339 were invented by Dr. Keppler at the University of Vienna.

Abdul Haleem's accomplice, Muhammad Ridzuan bin Md Ali, on the other hand, was sentenced to death for drug trafficking and later hanged on 19 May 2017. After the changes to the law, the first executions to take place were those of drug traffickers Tang Hai Liang and Foong Chee Peng on 18 July 2014, after their sentences were finalized and their refusal to further appeal against their sentences.

==== Slide preparation ==== Cells from bone marrow, blood, amniotic fluid, cord blood, tumor, and tissues (including skin, umbilical cord, chorionic villi, liver, and many other organs) can be cultured using standard cell culture techniques in order to increase their number. A mitotic inhibitor (colchicine, colcemid) is then added to the culture. This stops cell division at mitosis which allows an increased yield of mitotic cells for analysis. The cells are then centrifuged and media and mitotic inhibitor are removed, and replaced with a hypotonic solution. This causes the white blood cells or fibroblasts to swell so that the chromosomes will spread when added to a slide as well as lyses the red blood cells. After the cells have been allowed to sit in hypotonic solution, Carnoy's fixative (3:1 methanol to glacial acetic acid) is added. This kills the cells and hardens the nuclei of the remaining white blood cells. The cells are generally fixed repeatedly to remove any debris or remaining red blood cells. The cell suspension is then dropped onto specimen slides. After aging the slides in an oven or waiting a few days they are ready for banding and analysis.

Antigen presentation is the first step in educating the immune system to recognize new pathogens. To this end, antigen presenting cells expose protein fragments via MHC molecules to the immune system. Not all protein fragments bind, however, to the MHC molecules of a certain individual. Using mass spectrometry, the true spectrum of molecules presented to the immune system can be determined.

Sources: en.wikipedia.org

Frequently asked questions

What is epitalon made of?

Epitalon is a synthetic tetrapeptide built from four amino acids: alanine, glutamate, aspartate, and glycine. It is not extracted from a natural source but made in the laboratory by chemical synthesis. Its short length makes it relatively straightforward to produce at high purity.

Does epitalon occur naturally in the body?

No naturally occurring free form of the peptide has been described. The four-amino-acid sequence can appear as a fragment within larger proteins, but that is not the same as the intact compound being present as a circulating molecule. Materials used in research are synthetic.

How is epitalon purity checked?

Purity is usually checked by reverse-phase high-performance liquid chromatography, which separates the target peptide from related impurities. Mass spectrometry is commonly used alongside it to confirm molecular mass. Some suppliers also provide amino acid analysis for additional sequence confirmation.

What is epitalon made of?

It is a four-amino-acid peptide built from alanine, glutamate, aspartate and glycine in that order. Its formula is C14H22N4O9, and it is made by chemical synthesis rather than extracted from tissue. The synthetic peptide is a single defined molecule, unlike the pineal extracts it is often compared with.

Network